Search

SURI Quick Start Guide

HERE ARE A FEW TIPS TO GET YOUR SURI STARTED.

Charging Your SURI Toothbrush

Read More

Charging Your SURI Toothbrush

1. Charge

We recommend you charge your brush before first use. Plug your stand into any 5V USB 2.0 charger using the cable provided - most phone chargers work well. The light will blink blue and turn solid white when fully charged.

Read Less

Using Plant Based Heads

Read More

Using Plant Based Heads

2. Click

Slide your brush head on with the bristles facing the direction of the power button until it goes as far down as possible. We recommend you change your brush head every 3 months.

Read More Read Less

Read Less

Clean Mode and Polish Mode

Read More

Clean Mode and Polish Mode

3. Clean

Add a pea-sized amount of toothpaste on your brush head with a splash of water. Then push your brush's button to turn on Everyday Clean mode (white light). For best results pivot your brush head at a 45-degree angle towards your gum line and brush in small circles on your teeth. Your brush will make a haptic notification every 30 seconds for you to move to a different quadrant of your mouth and turn off after 2 minutes of use (the recommended brushing time).

1. Speeds: Your brush has two speeds, Everday Clean and Polish modes. We recommend you use the Everday Clean mode when first using a sonic powered brush. For a stronger clean you can push the button again to turn on polish mode (blue light).

2. Memory: When you turn the brush on in the first 10 seconds you can switch between modes (Everyday Clean & Polish) and off by pressing the button again repeatedly. After 5 seconds it will switch off no matter what mode you are in and when you turn it on again it will switch on to that same mode so you always use the same mode if you like. If you would like to move between modes again you can push the button quickly to cycle to off then the modes. Last if you hold the button for two seconds it will always turn right off in the mode you are in.

Read More Read Less

Read Less

Built-In UV-C Cleaning Case

Read More

Built-In UV-C Charging Case

4. Care

Your case’s built in UV-C light cleans your brush of 99.9% of bacteria in 1 minute. You can clean your brush head every week or so to keep it as fresh as possible. To charge or clean your brush with the case it needs to be plugged in.*

1. When plugged in, close the UV case and click the button on top to activate the 1 minute UV-C LED cleaning sequence.

2. Leave the case closed until the blue light on top turns off. A blinking blue light means the UV-C cleaning mode still active.

3. Your case can also charge your brush by connecting the provided cable to any 5V USB 2.0 charger.

Note to be bedroom friendly the case light wont indicate when charging, but your brush light will blink blue and turn solid white when fully charged.

*Your case does not contain a battery as we wanted to avoid additional batteries when not necessary.

**UV-C lights can be harmful to the eye so don’t open your case during the cleaning sequence.

Read More Read Less

Read Less

Good Brushing Habits Stick

Read More

Good Habits Stick

5. Good Habits Stick

Your brush comes with a separate mirror mount. Remove the adhesive cover and stick it on a clean mirror. The middle of your brush will magnetically stick to it now. Note it is not possible to re-stick your mount without replacing the adhesive tape so choose a good place first.

Read Less

Have More Questions?

Read More

Have More Questions?

6. Useful Links

Read Less

Shop Now

Save 25% with our launch price of £90 / $99

Shop Now

Search